![]() It is possible to “pause” driving, and then later “resume” following the leader’s trail, using the wait/resume action (RIGHT CTRL + H). If no “trail crumbs” can be found, or the vehicle already is followed by another, a warning will appear and you will have to either move a little bit further towards/back, or change to follow another vehicle. To follow some vehicle, point your own vehicle towards it and press the start action (RIGHT CTRL + F). So do remember to drive the leading vehicle some distance, before setting up the follower vehicle. Note: Each set of action-keys must use the same modifier-key!ĭo please note that, when loading a new map or savegame, the vehicles have not yet placed enough “trail crumbs” for other vehicles to follow. Press-and-hold RIGHT SHIFT + W/S to repeat decrease/increase in steps of 1. RIGHT SHIFT + W/S = Decrease/increase the follower’s distance to me, in steps of 5. Press-and-hold RIGHT SHIFT + A/D = Invert the follower’s offset. ![]() RIGHT SHIFT + A/D = Adjust the follower’s left/right offset, in steps of 0.5. RIGHT SHIFT + H = Pause/resume the follower. Press-and-hold RIGHT CTRL + W/S to repeat decrease/increase in steps of 1.īehind – To control the vehicle that is following behind me (if any): RIGHT CTRL + W/S = Decrease/increase following distance, in steps of 5. Press-and-hold RIGHT CTRL + A/D = Invert the offset. RIGHT CTRL + A/D = Adjust left/right offset when following, in steps of 0.5. RIGHT CTRL + H = Pause/resume following the vehicle that is in front. RIGHT CTRL + F = Start/stop following the vehicle that is in front (if possible). Myself – For the vehicle the player is driving: The action-keys, which can be changed in Options – Controls, are defined in two sets: vehicle-A follows vehicle-B follows vehicle-C follows vehicle-A – will make the beaconlights repeatedly turn on and off. – Turning on beaconlights, when having set up a circular convoy – i.e. This is most obvious when reaching a turn at high speeds, and trying to “get back on track”. – Some vehicles may start to zig-zag, in the attempt at following the “trail”, due to trying to touch every “trail crumb”. – The speed of followers may not always be 100% accurate as it could be, with regards to how fast/slow they should drive when following the “trail”. With the ‘Follow Me’ mod, a vehicle can be told to follow after another vehicle.īefore telling about the controls, here’s a list of known problems that may occur when you use it: Have you ever wanted to make a transport convoy, or just be able to cut grass – dry it – rake it – bale it – wrap it – pick it up, with multiple tractors all in one go? – Russian translations updated by Gonimy_Vetrom. – If baler is 95% full, then slower driving. – Stop engine when follower is stopped (other mods override this). – Ability to pause a follower (wait/resume). Remember to check the support topic for any additional information regarding this mod
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |